|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
VRSF 7" Intercooler DIY Done: Need Advice on Trimming Results (PICS)
|
|
06-29-2013, 10:38 PM | #1 |
First Lieutenant
70
Rep 374
Posts |
VRSF 7" Intercooler DIY Done: Need Advice on Trimming Results (PICS)
Hey guys,
Did my VRSF 7" intercooler install today. It went well aside from a stripped screw threading issue Anyways, based on what I've read here the goal was to trim as little of the front support away as possible. I did this successfully but the results look odd as the stock support is now going straight across the middle of the intercooler. What have you guys done? Just cut off the black plastic support altogether? Also, this intercooler sits a lot lower than the factory unit, but the mounting points are touching the stock mounting locations so i guess its just that this unit is a lot taller than the stock one? Help appreciated |
06-29-2013, 11:27 PM | #3 |
Brigadier General
578
Rep 4,393
Posts |
+1. I just took mine off entirely
__________________
< Click picture for photoshoot
E90 335i xDrive 6spd, Nav, Prem, Cold Weather, & Sports package - Msport Conversion Mods: JB4 + MHD, Doc Race ST, Pure 6266, AD-Eng PI/Mounts, Fuel-It st. 3, Custom Exhaust, Tuned by TwistedTuning More Pictures: Build Thread /// 683AWHP/675AWTQ |
Appreciate
0
|
06-30-2013, 12:40 AM | #4 |
Leeeroy Jankins
31
Rep 423
Posts |
Remove that junk covering that sexy intercooler.
Make sure it's flush against radiator
__________________
e90 LCI w/ -= VRSF 7" FMIC =-
-= Cobb: Stg1 +FMIC Aggressive ST =- Last Install: BMS DCI + Caliper/Drum Paint "If you're not 1st, you're last" -Ricky Bobby |
Appreciate
0
|
07-02-2013, 09:24 PM | #7 |
Captain
52
Rep 794
Posts |
RIP IT OUT! lol na bro just cut the center thingy lol
__________________
Gone But Not forgotten:
-07 Shelby GT500 W/ Full Bolt on E85 -08 335i 6MT W/ Full Bolt On E85/Meth -08 M3 DCT W/ Full Exhaust / Tune -13 B8 Audi S4 APR Stage 2+ |
Appreciate
0
|
07-02-2013, 10:43 PM | #9 |
FBO + e85 335i
3
Rep 80
Posts |
agreed man, I have the same one & I just took everything off. that plastic part only serves a purpose for supporting the stock intercooler. you don't need that anymore & looks way better without!
|
Appreciate
0
|
07-09-2013, 01:15 PM | #10 |
First Lieutenant
70
Rep 374
Posts |
|
Appreciate
0
|
Bookmarks |
|
|