|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Quarter size indentation in rear bumper cover
|
|
03-11-2010, 07:35 PM | #1 |
ahat
1036
Rep 2,592
Posts |
Quarter size indentation in rear bumper cover
It did not quite perforate but is very close. If I can remove the cover I can push it flat to make it much less noticable. Can someone give me the quick and dirty removing the bumper cover?
__________________
'13 335IS N54 (1 of 373 LeMans Blue out of 3597 total production e92)- Grey interior (1 of 24 in LMB with any trans- 1 of 14 with DCT)-MODS -MFactory LSD/MHD-BQ custom Tune/ATM-IC/AFE Momentum GT Intake/Konis/Mfront&HeimJoint Rear rods&arms/Brembos. https://photos.app.goo.gl/Lo6aHZRo7XqtPkhL8 |
03-11-2010, 08:16 PM | #2 |
Captain
25
Rep 635
Posts |
|
Appreciate
0
|
03-11-2010, 08:33 PM | #3 |
ahat
1036
Rep 2,592
Posts |
Thanks for the links
I was backing in a restaurant parking lot trying to get far enough over so the guy could pass and there was truck that had a receiver hitch sticking out. It was just about sunset and I could not see it in the pass rearview. Just barely caught the nut holding the ball at about a 90 degree angle. The body shop wants 550 for it. I think I can get it quite a bit better for a lot less than that if I can get the cover off. I knew I should have checked the DIY forum.
__________________
'13 335IS N54 (1 of 373 LeMans Blue out of 3597 total production e92)- Grey interior (1 of 24 in LMB with any trans- 1 of 14 with DCT)-MODS -MFactory LSD/MHD-BQ custom Tune/ATM-IC/AFE Momentum GT Intake/Konis/Mfront&HeimJoint Rear rods&arms/Brembos. https://photos.app.goo.gl/Lo6aHZRo7XqtPkhL8 Last edited by 335e92tx; 03-11-2010 at 08:40 PM.. |
Appreciate
0
|
Bookmarks |
|
|