|
10-14-2022, 10:43 AM | #3 |
Lieutenant
667
Rep 559
Posts |
I emailed them and they don't know if its fits or not.
Theres another company I found 3d spyder. They don't specify the model, but unconfirmed if it fits all. I've been busy to compare the shapes to see if they fit or not and if the tuxmat would fit as well. |
Appreciate
1
nearwater4me2054.00 |
10-14-2022, 11:16 AM | #4 |
Occasionally frequent poster
3054
Rep 2,767
Posts |
Sounds like they need a test vehicle. You should offer to do it for them in exchange for a discount/freebie.
My thinking is that regardless of the number of pedals, the floor is unchanged between models, so it should fit fine. And of course, there should be an OEM solution that would fit, and I would certainly try Weathertech.
__________________
Current inventory:
F22 Cadillac CT5-V Blackwing w/3 pedals, a plastic Chevy & Porsche Soccer Mom car Past: E24,E28(3),E34,E36,E37,E38(2),E39(4),E46,E89,E92 (obviously),F01,F06,F10,F30,F87,G12,G30(2),G82(2) |
Appreciate
1
nearwater4me2054.00 |
10-14-2022, 12:43 PM | #5 | |
Lieutenant
667
Rep 559
Posts |
Quote:
Has weathertech changed their forumula? I'm not a fan of how they look ashy after 6 months. |
|
Appreciate
0
|
10-14-2022, 12:50 PM | #6 |
Lieutenant
667
Rep 559
Posts |
I'm going to gamble it... They offer a prepaid return label. Nothing to lose
|
Appreciate
1
nearwater4me2054.00 |
10-14-2022, 02:58 PM | #7 |
Colonel
2054
Rep 2,241
Posts |
|
Appreciate
0
|
10-14-2022, 07:18 PM | #8 |
Lieutenant
667
Rep 559
Posts |
|
Appreciate
1
nearwater4me2054.00 |
10-18-2022, 09:06 PM | #10 | |
Lieutenant
667
Rep 559
Posts |
Quote:
Thank you! Yep, anyday now! I try to get them in day 1. =) Beyond protecting, it makes cleaning the interior so easy. I have a large air compressor and just blow everything out. Wipe dash, seats then floor with the same 2-3 towels. 5-7 min and the interiors done(I own full service car washs, got it down to a science lol) |
|
Appreciate
1
nearwater4me2054.00 |
01-04-2023, 02:19 AM | #11 |
New Member
66
Rep 24
Posts |
|
Appreciate
0
|
01-10-2023, 07:26 AM | #12 |
Lieutenant
667
Rep 559
Posts |
They fit rwd cars perfect! I will say that I did trim mine a little around the clutch pedal. I remove it every week to clean and don’t want to spend 5-10 min tweaking to prevent any rubbing. I ride mtb 3x a week and track a lot of crap on the driver side.
|
Appreciate
0
|
01-17-2023, 08:58 AM | #13 | |
Colonel
2054
Rep 2,241
Posts |
Quote:
I received mine yesterday and installed it within minutes. I'm not sure if the rear seat dimensions are different on G82 vs. G80, but the back wall of the rear mat is about an inch too tall that it covers part of the rear seat bottom. Just wondering if you have the same issue. Not that I have any passengers sitting in the rear, but it's not a 100% fitment IMO. |
|
Appreciate
0
|
01-17-2023, 04:30 PM | #14 |
Colonel
3241
Rep 2,470
Posts |
You did buy the 4 series mats right?
__________________
|
Appreciate
1
nearwater4me2054.00 |
01-17-2023, 11:48 PM | #15 |
Private
285
Rep 65
Posts |
I have the regular 3 series tuxmats in my G80 6MT and they fit perfectly fine. I will admit, when pressing the clutch fully to the floor, it’s probably about 1/4” less travel than without the tuxmat. I’ve had them in for over 4,000 miles now though, and it has never been a problem. If anything, it’s nice to slightly reduce the amount of travel in the pedal with every shift. Our cars have significantly more clutch travel than needed IMO. Reducing that last 1/4” or so has never caused me to miss/grind a gear though. I enjoy it more than without the mats. Never considered trimming it like RACE M3 But I can see some would.
I also never remove them to clean as I used several of the provided clips to hold it in place. They vacuum so easily and wipe right off with a wet towel. Plus the coverage is insane, all the way up the gear tunnel and door sills. Haven’t needed to remove. |
01-18-2023, 09:22 AM | #16 |
Colonel
2054
Rep 2,241
Posts |
|
Appreciate
0
|
09-10-2023, 01:00 PM | #18 |
Lieutenant
667
Rep 559
Posts |
|
Appreciate
2
Tobstertx3220.50 LuckyBrand1768.50 |
10-14-2023, 05:40 PM | #19 | |
Lieutenant
649
Rep 491
Posts |
Quote:
Picked up a G20 330iX yesterday. Site says xdrive and electric is a no go. Does anyone know if these will fit the xdrive version?
__________________
2022 X3MC
2020 330iX Daily 2002 R34 Mspec Nur -in Canada 2014 S4 APR stg1 444hp retired 2010 335d; 2004 WRX wagon; 1994 300ZX -retired |
|
Appreciate
0
|
10-15-2023, 06:51 PM | #20 | |
Lieutenant
667
Rep 559
Posts |
Quote:
The floor layout is the same for all 3 series vehicles. The m3 mats will fit your car perfectly. |
|
Appreciate
0
|
10-15-2023, 09:13 PM | #21 | |
Lieutenant
649
Rep 491
Posts |
Quote:
__________________
2022 X3MC
2020 330iX Daily 2002 R34 Mspec Nur -in Canada 2014 S4 APR stg1 444hp retired 2010 335d; 2004 WRX wagon; 1994 300ZX -retired |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|